Home > Industry knowledge > Content

Installation and Use of Wireless Infrared Detector

Sep 30, 2019

Installation and Use of Wireless Infrared Detector


1. Code skipping: It has been set when leaving the factory. If not, please refer to the legend and set the corresponding 8-bit data code and 4-bit address code against the host.


2. Installation instructions: Before use, please jump the short-circuit cap under the battery socket from OFF to ON.


A) Open the shell, connect the 9VDC battery, and the detector will work.


B) Put the disassembly-proof switch to send a signal to the host at one time.


C) Buckle the upper shell, install the universal bracket of the detector and adjust the detection angle (the wall of the detector should be firm and stable, without swing). Installation, as shown in Figure: Vertical Installation


D) After power-up, the indicator lights on for about 2 seconds, the detector continues to delay about 3 seconds or 30 seconds (determined by the position of the selection block of the defense time jumper) and then enters the alert working state. When the detector enters the detection area in the alert state, the detector immediately outputs a signal to start the host alarm.


3. use:


Walking test: The defense time is selected at the position of 3 seconds to simulate the intruder's activity in the detector area. The indicator lights on for about 2 seconds, and the detector emits an alarm signal. At this time, the host of the alarm should receive the signal.


B. After normal walking test, the fortification time should be selected at the position of 30 seconds for alert use.

Wireless Alarms Detector